Access VIRUS CLASSIC Bedienungsanleitung PDF herunterladen (Seite 31)

OCILLATOR

FiltEnv>H-Sync •

-64 to +63: Controls how much lter envelope is applied to. Only visible if at least one of the oscillators is in

HyperSaw mode.

HyperSync Offset. Analogous to FiltEnv>FM in the other oscillator models. If oscillators 1 and 2 are both Hy-

perSaws, this parameter modulates the Sync Offset of both oscillators at the same time. Note that it will not

effect oscillator 1 if SYNC is not active.

Modulation destination “FiltEnv>FM/Hsync”.

H-Sync Offset •

0 to 127: The frequency offset of the audible HyperSaw with

Only visible if at least one oscillator is in HyperSaw mode. Directly accessible from the panel via FM Amount.

respect to its own internal “master” oscillator. Modulation destination “FM/HyperSync”.

Sub Oscillator

An extra “slave” oscillator tuned an octave below its master oscillator. If oscillator 1 is in Classic mode, the

sub-oscillator is a Square or Triangle wave slaved to oscillator 1. If either oscillator 1 or 2 is in HyperSaw

mode, the sub oscillator is HyperSub instead

Volume •

0 to 127: Sub oscillator mix. In HyperSaw mode, this parameter crossfades between HyperSaw and Hyper-

Sub.

Modulation destination “SubOscVolume“.

Shape •

Square, Triangle: Selects the sub oscillator waveform.

Not available if oscillator 1 is in HyperSaw or WaveTable mode. See “About HyperSaw and SubOscillators”

Noise

Volume •

Off, 1 to 127: The level of noise. If set to Off, the Color parameter will not be visible.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 94 95

Keine Kommentare

Access VIRUS CLASSIC Bedienungsanleitung Seite 31